GE Profile PW9000SFSS User Manual download pdf (Page 12)

Parts provided: 4 Wood screws

Place carton on a flat surface.

Open one end of the carton and lift off the top piece.

Lift the warming drawer up and out of the carton.

Place the drawer on top of the shipping carton to protect

the drawer front and the finished flooring.

Remove all packing materials and tape.

Locate package containing 4 wood screws and set aside.

Installation Below a Countertop

 When installed, the front face of the warming drawer will be

nearly flush with cabinetry doors or drawer fronts.

 Drawer overlaps will conceal cut edges on all sides of the

opening.

The rough opening for the drawer must be:

³'HSWK 23

ø2” minimum from inside back to front of cabinet

frame.

³:LGWK 25

ø2” for 27" wide models

ø2” for 30" wide models.

³+HLJKW 9

ø4”

 5” minimum above floor or 1" above toekick. 23

ø4” from floor

to bottom of cutout is recommended for under countertop

installation.

Installation below a cabinet drawer:

The warming drawer may be installed beneath a cabinet

drawer. In this installation, a solid barrier should be installed

above the warming drawer to block access. Use any solid

material such as 1/4" thick plywood. Allow at least 1/4" air

gap between the barrier and the top of the warming drawer.

Observe the 5" min. above the floor or 1" above the toekick min.

installation height.

NOTE: If you are installing in frameless cabinets, it may be

necessary to install 1/2" wide cleats to accept drawer mounting

screws. See drawer to find exact locations of mounting screws.

When installed under a cooktop:

Warming drawers are suitable for installation below only certain

specified cooktop models. See the label attached to the top of

the warming drawer for suitable models. A solid barrier and air

gap between cooktop and warming drawer is required. See

Note above.

Installation of the warming drawer.

Read these instructions completely and carefully.

Remove Packaging and Parts

Electrical outlet 42"

max. from right side

1" Min.*

25"

ø4”

ø2” Min.

36"

Countertop

height

Electrical

outlet 16” max.

from left side

Electrical outlet

flush with side of

cabinet 7" max.

Install 2x4 or 2x2

anti-tip block against

rear cabinet wall 9”

from floor to bottom

of block

ø2” Cabinet top

Install a solid barrier

and a 1/4” min. air

gap above warming

drawer

1/4” Air gap

Solid barrier

Install a solid barrier below

a cooktop (see Note)

IN CANADA THIS DRAWER IS NOT

APPROVED FOR INSTALLATION

UNDER A COOKTOP.

*NOTE: When installing the warming drawer below a cooktop, a solid

barrier must be installed at least 1"from the lowest point of the bottom

of cooktop burner box to the top of cutout. Use any solid material such as

1/4" thick plywood. Allow at least 1/4 "air gap between the barrier and the

top of the warming drawer. See label on top of the wa rming drawer for

approved cooktop models.

Dimension A

27 " Drawer 30 " Drawer

ø2” 28

ø2”

CAUTION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

GE Profile PW9000SFSS User Manual Page 12

Comments to this Manuals