GE Profile PHB920SJSS Use and Care Manual download pdf (Page 24)

49-80765

Use

gloves or

cloth

Receptacle

G9 Bulb

Socket

Tab

Glass cover

Receptacle

Maintenance

CARE AND CLEANING: Maintenance

SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical

power to the range at the main fuse or circuit breaker panel. Failure to do so may result

in electric shock or burn.

WARNING

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot

glass with bare hands or a damp cloth can cause burns.

CAUTION

Oven Light Replacement (on some models)

To remove:

1. Turn the glass cover counterclockwise 1/4 turn until

the tabs of the glass cover clear the grooves of the

socket. Wearing latex gloves may offer a better grip.

2. Using gloves or a dry cloth, remove the bulb by

pulling it straight out.

To replace:

1. Use a new 120/130-volt halogen bulb, not to exceed

50 watts. Replace the bulb with the same type of bulb

that was removed. Be sure the replacement bulb is

rated 120 volts or 130 volts (NOT 12 volts).

2. Using gloves or a dry cloth, remove the bulb from its

packaging. Do not touch the bulb with bare fingers.

Oil from skin will damage the bulb and shorten its life.

3. Push the bulb straight into the receptacle all the way.

4. Place the tabs of the glass cover into the grooves of

the socket. Turn the glass cover clockwise 1/4 turn.

For improved lighting inside the oven, clean the glass

cover frequently using a wet cloth. This should be

done when the oven is completely cool.

5. Reconnect electrical power to the oven.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

No comments

GE Profile PHB920SJSS Use and Care Manual Page 24