GE Profile PK7000DFBB Installation Manual download pdf (Page 7)

MOUNT THE OVEN

WARNING: Mounting screws

must be used. Failure to do so could result in

the oven falling out of the cabinet, causing

serious injury.

NOTE: During oven mounting step, ensure that no

damage is done to oven gasket which lines the

edge of oven cavity.

NOTE: Before drilling the pilot holes, make sure

the oven is pushed as far back into the opening

as it will go and is centered.

NOTE: If the cabinet is particle board, you must

use #8 x ¾” particle board screws. These may be

purchased at any hardware store.

A. Drill through the mounting holes (top and

bottom) of the side trim for the #8 mounting

screws provided.

B. Secure the oven cabinet with the screws

provided.

Mounting

Hole

Locations

(hole locations

may vary)

BOTTOM TRIM INSTALLATION

• With oven installed, attach the bottom trim through its mounting holes in front vertical brace using

two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.

IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service,

the bottom trim must be removed first or damage to the trim will occur.

The Screws

Must Be a

Minimum of

1/4” (6 mm)

From the

Front of

the Cutout.

SWO’s and DWO installations without pedestal

DWO’s with pedestals

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

GE Profile PK7000DFBB Installation Manual Page 7